Futaba EBB1164 Sensor SBS-01C E-TOP, Current (FTREBB1164)

Futaba EBB1164 Sensor SBS-01C E-Top, Current

Brand:Futaba
Stock Code:Ftrebb1164
Type:Sensor

Sensor box content

• 1 Futaba SBS-01C E-Top Sensor

Sensor Features

• Usage: Electrical power system current and capacity monitoring sensor.
• Current: 0a ~ 150a 12 ga silicone wire
• Voltage: 0V ~ 70v
• Consumption Capacity: 0 MAH ~ 32767 MAH
• Weight: 23 g - 0.81 ounce
• Voltage: DC 3.7 ~ 7,4V
• FLOW:
  *0a ~ 70a
  70a ~ 150A (in 10 seconds)
  *Under 1a measurement cannot be made
• Insurance (can be installed in both directions) 1A @ 125VDC

You can find the ingredients you need to finish this product at the bottom of the page

Futaba SBS-01C is a device used as current and capacity monitoring sensor. Usually model aircraft, drones or other radio controlled devices are preferred to monitor battery flow and capacity.

This sensor follows the current withdrawn from the battery, determines how much power the battery consumes and how much energy remains. It can also measure the capacity of the battery. It provides information about the power status of the device by providing the current consumption and current capacity of the battery in real time.

Such sensors are very important for battery management. Monitoring the instant consumption of the battery is important in terms of preventing excessive discharge or overload conditions and protecting the health of the battery. It also provides guidance to the user that it should charge or replace the battery.

Futaba works with the donors below:
T18MZ (World Champion)
T18SZ
T18SZ (70th Anniversary)
T16
T16SZ
T10px
T7px
T7px

About Futaba

Futaba Corporation was founded in 1948 as a manufacturer and seller of receiving vacuum tubes in Japan. Futaba, which uses vacuum tube technology, has started to produce vacuum fluorescent screens. In 1962, Futaba began to produce a press mold set components as well as radio control equipment and founded two of the primary sections of the company. This was followed by the development of mold basic components and the addition of VFD modules to complete the futaba's main product range. Our company's US -based branch Futaba Corporation of America (FCA) supports the same technologies and is the leading provider of electronic production services. (EMS) includes PCB devices to complete box construction, test and engineering design.