Futaba 05003226 26SZ Aircraft Remote, R7214SB Receiver, 2.4Ghz, Li-Po Battery, FASSTest,T-FHSS,S-FHSS (FTK5003226)

Futaba 05003226 26Sz Aerial Vehicle Control, R7214SB Receiver, 2.4GHz, Li-Po Battery, Fassstest, T-FHSS, S-FHSS

Brand:Futaba
Stock Code:FTK5003226
Type:Control

Content

• 1 Piece 26sz Air Vehicle Control
• 1 buyer

Features

• -T26SZ transmitter can be changed to MOD-1 or MOD-2 in software.
• -FassStest26, FassStest18, Fassestest12, S-FHSS and T-FHSS protocols
• - 26 channels (24+2)
• - FULL Color 4.3 -inch touch screen
• - 3.0 inch LCD sub -screen
• - High quality coating
• - Model image screen
• - Smooth contactless rod potentiometer
• - Raising / replacement of shoulder key
• - Four rear slider (paired)
• - vibrating warning
• - Sound function
• - Telemetry System
• - Four rod mode (1-4)
• - MicroSD Card Software Update
• - High capacity lipo
• - USB-C charge
• - headphone jack
• - Canel clock
• - S.BUS I/F EFFICIENT
• - Wireless Instructor System
• - ± 240 steps sub -trim
• - Lower Trim Balance
• - DLPH-2 Settings
• - Receiver Mode Adjustment Port
• - Jyroscope setting for CGY755 / 760r / 770r / GYA553
• - 8 flight conditions
• - 30 pre -programmed mixer
• - 10 Free Programmable Mixer
• - withdrawal and door ranking
• - 13 fixed wing types
• - 3 fixed wing tail type
• - 2 fixed wing rudder type
• - 8 helicopter swing type
• - 14 Supports Telemetry Sensor Type
• - GPS is active

You can find the ingredients you need to finish this product at the bottom of the page

Basic Programming Features:
- model name (15 characters)
- Alt Trim
- Lower Trim Balance
- Servo Back
- Fault safe
- Master
- Cutting gas
- End Point / ATV (30 - 140%)
- servo speed
- Trainer function
- servo monitor
- trim setting (Step, Ratio, Mod)
- Data Editor (for S.BUS equipment)
- 10 programmable mixer
- 30 pre -programmed mixer
- Aileon differential
- Air brake
- Flap Triim
- flap setting
- Butterfly
- Kamber mixture
- Kamber Flap-Asansor
- From the elevator to kambe
- Kamber Flapine from Aileon
- From Aileon to the rudder
- V tail
- Ailevator
- Wedding
- Brake flapine from Aileon
- Instant turn
- servo monitor
- Binary Timaries
- rod alarm
- Battery fault safety
- gyroscopic detection
- Multiple engine
- engine mixture
- Status Name
- AFR (Double Ratio)
- AFR (curved mode)
- AFR Curve Point Number (17 Points)
- Logic Switch (status key only)
- acceleration mixing
- inclination curve / slope trim
- gas curve / gas butterfly navigation trim
- Slope-Iğne mixture
- cycle mixture
- The slope ring
- The idle is down
- gas limiting
- Tilk setting
- inclination AFR
- System Timer
- Function Setting
- Regulator

Telemetry functions:
- Heat
- RPM (magnetic and optical)
- altitude
- GPS
- voltage
- Receiver battery
- Flow
- data recording

About Futaba

Futaba Corporation was founded in 1948 as a manufacturer and seller of receiving vacuum tubes in Japan. Futaba, which uses vacuum tube technology, has started to produce vacuum fluorescent screens. In 1962, Futaba began to produce a press mold set components as well as radio control equipment and founded two of the primary sections of the company. This was followed by the development of mold basic components and the addition of VFD modules to complete the futaba's main product range. Our company's US -based branch Futaba Corporation of America (FCA) supports the same technologies and is the leading provider of electronic production services. (EMS) includes PCB devices to complete box construction, test and engineering design.